2:53:47 PM - DSC DEBUG - Sending command to panel. 2:53:35 PM - DSC DEBUG - Sending command to panel. 2:53:34 PM - DSC DEBUG - Sending command to panel.
2:53:34 PM - DSC Security - Partition 1 armed from website by user XXXX When I try to arm the panel from the plug-in, NOTHING.
#Dsc dls programming keyfob serial#
All my serial signals are sent over Cat5e (<20 feet), and I have used the following straight-through pin-out for DB9-RJ45 connectors: This converter works perfectly with my other serial devices, including the PC-LINK that I use to communicate with the PC1832. I am using a USB-to-serial converter with an FTDI chipset. The IT-100 baud rate is set to 9600, which is the unchanged default on the IT-100 module. In the plug in configuration, I have the master code entered correctly, and I have two user codes entered correctly. I am not sure if I should have enabled communications for the IT-100 (section - 1), which will be my only source of monitoring for now. There's no land line connection here, so communications and telephone line monitoring is disabled, sections -1 and -7, respectively.
A DSC wireless module shows up as RFK5132 version 5.3, presumably because this is built in to the RFK5501. I used the PC-Link and DLS V to program the panel, enroll wireless sensors/key fobs, and enroll an RFK5501 (shows up as Keypad 1 in the software) and the IT-100 (which shows up in slot 8 as PK5500 version 1.0 after auto detection from DLS V). This is a DIY installation of a PowerSeries PC1832 version 4.6CP-01. I've been trying to get my DSC IT-100 communicating with my PC1832. IT-100 (HomeSeer, March 2014), enrolled in slot 8 through DLS V (PK5500 version 1.0).Keypad: RFK5501 (wireless RFK5132 version 3.0)